YFU Amblemi

YAPI FİZİĞİ
UZMANLIK
UYGULAMALARI
San. ve Tic. A.Ş.

Info about YFU
Administrative
Field of Activities
Price List
YFU Publications
Reference List
Illumination Vocabulary

ANASAYFA / HOME

Vefabayırı Sok. No.38
Gayrettepe
34349 İstanbul

TÜRKİYE

Address Sketch

Tel.: +90 212 2753588
Fax.: +90 212 2673962
E-Mail: yfu@yfu.com

dalgalan.gif (42024 bytes)

 

 

 

YFU Amblemi

 

 

 

YFU Amblemi

 

 

 

YFU Amblemi

 

 

 

YFU Amblemi

PRICE LIST                                              Updated on : 01.01.2005

» Goniophotometric measurements
» Integrating sphere measurements
» Reflector design
» Miscellaneous measurements


*  Prices are given in  Euro ().
*  Prices do not include official tax
     (if invoice is written to foreign address, no tax is applied).



GONIOPHOTOMETRIC MEASUREMENTS:                                              (Top)

For every luminaire fastening 70,-
For every goniophotometric measurement at :
15° steps for planes 50,-
10° steps for planes 65,-
5° steps for planes 110,-
For each Eulumdat (*.ldt) file 10,-
For trafic lamp measurements 85,-
  • Prices are given for luminairs being symmetric in planes C0-C180 & C90-C270,
    in plane C0-C180 or in plane C90-C270, which give light only to either lower or
    upper hemisphere, where measurements in planes are made in 2.5° steps.
  • For non-symmetric luminaires measurement prices should be multiplied by 1.5.
  • For rotational symmetric luminaires measurement prices should be multiplied by 0.7.
  • If a luminaire gives light to the upper sphere not exceeding 140° and if the geometry
    of it is suitable for measurement in one go, measurement prices are multiplied by 1.3
  • For luminaires sending light in both hemispheres and where the measurements in
    planes have to be made from  0°-180°, prices both for fastening and measuring
    should be multiplied by 2.
  • If measurements in planes are made in 5° steps, measurement prices are multiplied with  0.7.
  • If measurements in planes are made in 1.25° steps, measurement prices are multiplied with  1.5.
  • If measurements in planes are made in 0.5° steps, measurement prices are multiplied with  2.
  • For cases other than explained above, ask for special prices.
  • The exact lumen output of the lamp(s) used in the luminaire to be measured should be
    known. Therefore, if the lamp has not already a secondary standart certificate, it should
    be meausered in the integrating sphere by YFU.



INTEGRATING (ULBRICHT) SPHERE MEASUREMENTS:                     (Top)

For every lamp 95,-
For same type of lamps after the first one 65,-
For every luminaire light output ratio measurement 150,-

The lamps to be measured in integrating sphere should be aged at least for 100 hours.


REFLECTOR DESIGN:                                                                                    (Top)

Reflectors for point light sources:
Simple rotational reflector 500,-
Complex rotational reflector 800,-
Reflector which should comply  to a certain standard 1.200,-
Reflectors for line light sources:
Simple reflector for sources like: straight Fl, compact Fl, long halogen  400,-
Reflectors necessitating translations of straight lines or  curves 600,-


MISCELLANEOUS MEASUREMENTS:                                                      (Top)

Regular or diffuse reflectance 60,-
Regular or diffuse transmittance 60,-
Absorbtance 120,-
Diffusion factor by reflectance 90,-
Diffusion factor by transmittance 90,-
Luminance (mean value) for primary light source 60,-
Ratio of min.-max. luminance values for primary light source 80,-
Louminous homogeneity ratio for traffic signal heads 80,-
Phantom signal for traffic signal heads 120,-


Note:
*  Prices are given in  Euro ().
*  Prices do not include official tax.
     (if invoice is written to foreign address, no tax is applied).




For comments please send an  e-mail   to Osman Sirel.